Why not a 24t for ripping?

I’ve seen his recommendation too but that’s another 2x price jump over the price range I’m already trying to avoid!

I was misremembering because my block plane blade has multiple notches like this example. My larger planes don’t. Example blade: https://www.leevalley.com/en-us/shop/tools/hand-tools/planes/blades/117808-o1-stanley-block-plane-blades-made-by-veritas?item=05P3173

Does the blade have multiple notches to allow adjustment as you sharpen it? Are you using the notch that makes the blade shortest?

Yes, thanks! I have clamped one piece to guide my router before, but using two would be much easier since it eliminates the need to measure the offset to the “far” stop every time. Clever!

Can you elaborate on this a bit?

https://ibuildit.ca/projects/wooden-vise/ Cool!

Thanks. Interesting point that even a small bolt is going to be plenty strong for work-holding. So maybe just some all thread of appropriate length? I guess the problem there is the pitch is fine, so it would move very slowly.

Out of curiosity, when do you care about the jaw being flush with the workbench top?

Thanks!

Thank you. On the 1/8 table saw blade, your concern is that you prefer narrower, lighter blades?

Do you have any particular recommendations for identifying quality router bits?

Fortunately it looks like the federal courts don’t allow this any more: https://www.ussc.gov/about/news/press-releases/april-17-2024

But of course the state courts have their own separate rules.