I’ve hit a wall with a weird Wireguard issue. I’m trying to connect my phone (over cell) to my home router using wireguard and it will not connect.

  • The keys are all correct.
  • The IPs are all correct.
  • The ports are open on the firewall.
  • My router has a public IP, no CGNAT.

The router is opnsense, I have a tcpdump session going and when I attempt a connection from the phone I see 0 packets on that port. I am able to ping the router and reach the web server sitting behind it from the phone.

I have a VPS that I configured WG on and the phone connects fine to that. I also tested configuring the VPS to connect to my home router and that also works fine.

I’m really at a loss as to where to go next.

Edit 2: I completely blew out the config on both sides and rebuilt it from scratch, using a different UDP port, and it all appears to be working now. Thanks for everyone’s help in tracking this down.

Edit: It was requested I provide my configs.

opnsense:

####################################################
# Interface settings, not used by `wg`             #
# Only used for reference and detection of changes #
# in the configuration                             #
####################################################
# Address =  172.31.254.1/24
# DNS =
# MTU =
# disableroutes = 0
# gateway =

[Interface]
PrivateKey = 
ListenPort = 51821

[Peer]
# friendly_name = note20
PublicKey = 
AllowedIPs = 172.31.254.100/32

Android:

[Interface]
Address = 172.31.254.100/32
PrivateKey = 

[Peer]
AllowedIPs = 0.0.0.0/32
Endpoint = :51821
PublicKey =
  • Mikelius@lemmy.mlEnglish
    0·
    11 months ago

    Is wireguard hosted on opnsense, or an internal device that the port is being forwarded to?

    If it’s on opnsense, be sure you route outgoing traffic on that port over the correct gateway, possibly even an extra rule to be sure the proper reply-to is set. Opnsense used to do the gateway routing configuration automatically, but once wg got added to the kernel, you’re now required to manually specify the gateway in your rules for it to work properly.

    Also, if you see zero packets, then as others mentioned, try a different mtu. Some service providers (mobile, and even hotels) try to block all VPN traffic altogether and they do this by measuring the mtu of the packets. A little tweaking might get it to work, although I’d expect this to have held true for the VPS too, honestly.

    • 𝓢𝓮𝓮𝓙𝓪𝔂𝓔𝓶𝓶@lemmy.procrastinati.orgOPEnglish
      1·
      11 months ago

      Is wireguard hosted on opnsense, or an internal device that the port is being forwarded to? opnsense. I do have the interface and gw configured and was able to successfully connect when I did the test config from my VPS.

      Also, if you see zero packets, then as others mentioned, try a different mtu. Some service providers (mobile, and even hotels) try to block all VPN traffic altogether and they do this by measuring the mtu of the packets.

      I didn’t think about MTU. I’ll do some research and testing on this today.

      A little tweaking might get it to work, although I’d expect this to have held true for the VPS too, honestly.

      This is why I’m struggling. Every test I do is successful, by all rights this should be working. Phone to VPS, GOOD. VPS to opnsense, GOOD. Phone to VPS, BAD. Can I see packets from the phone to opnsense, YES, unless it’s wireguard.

      I’ll experiment with MTU and see if that bears and fruit. Thanks.